Porsche Tire Tips

P
is for Pressure
Under-inflation is a tire's prime enemy. It results in unnecessary tire stress, irregular wear, loss of control & accidents. A tire can lose up to half of its air pressure and not appear to be flat!


A
is for Alignment
Is your vehicle pulling to one side, or shaking? A bad jolt from hitting a curb or pothole can throw your front end out of alignment and damage your tires. Have us check the alignment periodically to ensure that your car is properly aligned.

R
is for Rotation
Regularly rotating your vehicle's tires will help you achieve more uniform wear. Unless your vehicle owner's manual has a specific recommendation, the guideline for tire rotation is approximately every 5,000 miles.

T
is for Tread
Measure it and inspect it. Advanced and unusual wear can reduce the ability of tread to grip the road in adverse conditions. Visually check your tires for uneven wear, looking for high and low areas or unusually smooth areas. Also check for signs of damage.

Do your PART!

Proper tire care and safety is simple and easy. We recommend checking your tires monthly, including the spare. If you think you may have a tire problem or are unsure of the condition of your tires, consult one of our Service Advisors as soon as possible.

Contact

Porsche Norwell

75 Pond St
Directions Norwell, MA 02061

  • Sales: 855 583-8081
  • Service: 855 583-8081
  • Parts: 855 583-8081

Tire Pressure

Make sure you check your tire pressure regularly - at least once per month and before every long trip (including the spare) - and keep it at the level recommended by the vehicle manufacturer. The correct cold inflation pressure for your tires is listed on the vehicle label on the door post, fuel door, glove box or in the owners' manual. "Cold inflation pressure" refers to the pressure in a tire that has not been driven for at least three hours. As tires warm during driving, it is normal for pressure to build up. Never "bleed" or reduce air pressure when tires are hot.The tire pressure listed on your sidewalls is the maximum pressure and is not intended to serve as notification of the correct pressure. Under inflation creates excessive stresses and heat and may lead to tire failure. It is also important to guard against overinflation, which can cause uneven wear plus handling and stopping problems.

Overloading

Before you fill the trunk and the roof rack with your stuff, check out the vehicle manufacturers recommendations for loading your vehicle. You may not realize it, but you and your passengers count towards the total recommended vehicle weight.The vehicle manufacturers loading recommendation can be found on the vehicle information placard on the door post or in the vehicle owners' manual. Overloading your vehicle creates excessive heat inside your tires. Excessive heat can cause tire failure that could result in vehicle damage and/or serious injury or even death. And don't forget, if you are going to be driving long distances with a loaded vehicle, or if you haven't had your car checked in a while, have the alignment and rotation checked. Tires and wheels that are out of balance or misaligned can cause uneven wear or vehicle problems. Have your car checked by an automotive service professional before you leave.

Tire Tread

Check the tread grooves of your tires to make sure that they're free of foreign objects. This makes it easier for your tires to grip the road and increases your ability to safely maneuver your car.Also check the sidewalls to make sure there are no gouges, cuts, bulges or other irregularities.You may have irregular tread wear if there are high and low areas or unusually smooth areas. Built-in treadwear indicators, or "wear bars," which look like narrow strips of smooth rubber across the tread will appear on the tire when the tread is worn down to one-sixteenth of an inch. When you see these "wear bars," the tire is worn out and should be replaced.